Products list

Download list

The components of radiello

The essential parts of radiello are the adsorbing cartridge, the diffusive body, the supporting plate and the adhesive label with the bar code indication. Apart from the adsorbing cartridge, if not differently stated, all of the other components can be used for a lot of sampling experiments.

The adsorbing cartridge

Depending on the polluting compound to be sampled, several different kinds of adsorbing or chemiadsorbing cartridges have been developed. Their dimensions are neverthless the same for all: 60 mm length and 4,8 or 5,8 mm diameter.
Theiy are contained in glass or plastic tubes wrapped up in a transparent polyethylene thermowelded bag.
The code number, printed onto the bag along with the lot number and expiry date indicates the kind of cartridge.
Apart from the thermal desorption cartridges, all of the other kinds are for single use only.

Available in 5 or 20 pieces per package only.
The cartridge has to be introduced into the diffusive body.

The supporting plate

It is identified by the code 121. Made of polycarbonate, it acts both as closure and support for the diffusive body, which has to be screwed onto the thread. It comes along with a clip and a transparent adhesive pocket to hold the label. The three parts are to be assembled before use.

Available in 20 pieces per package only.

The diffusive body

Four kinds of diffusive bodies are available, with like outer dimensions: 60 mm height and 16 mm diameter.

The white diffusive body, code 120, of general use, is made of microporous polyethylene 1.7 mm thick and average porosity 25 ± 5 µm. Diffusive path length is 18 mm.

The blue diffusive body, code 120-1, has the same properties of the white one but is opaque to light: it is suited to the sampling of light-sensitive compounds.

The yellow diffusive body, code 120-2, should be used whenever the sampling rate must be reduced; it is made of microporous polyethylene 5 mm thick and average porosity 10 ± 2 µm. Diffusive path length is 150 mm.

The permeative diffusive body, code 120-3, is a 50 µm thick silicone membrane strengthned by a stainless steel net. It is employed for anaesthetic gases and vapours sampling.

Available in 20 pieces per package only.
The diffusive body has to be screwed onto the supporting plate.

The label

Self-adhesive, with printed barcode number. Since each barcode number has been printed in only one copy, it allows an unmistakable identification of the sampling tube on field and in the laboratory for the subsequent analysis.

Each package of 20 adsorbing cartridges contains also 21 labels.
If ordered separately, they are shipped in 198 pieces per package only.


download the complete radiello manual or the individual chapters in pdf.

Download pdf


access sampling and analysis methods


Calibration Kit

Discover the ready-to-use calibration kits for your calibration curves


Full proof

Discover the radiello ready-to-use...for those who have little time!



how to maintain radiello components: from diffusive bodies to supporting plates.



all accessories available for radiello: from self-adhesive barcode labels, to test tubes, clips, weatherproof boxes and data logger thermometers...